Home › BODY › ENGINE HOOD / DOOR › FRONT DOOR

FRONT DOOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY


  1. Check that the clearance measurements of areas A through P are within each standard range.


    B172917E02


    Standard clearance:

    Area
    Measurement
    Area
    Measurement
    A
    2.9 to 6.9 mm (0.114 to 0.272 in.)
    I
    2.5 to 5.5 mm (0.098 to 0.217 in.)
    B
    3.0 to 6.0 mm (0.118 to 0.236 in.)
    J
    4.2 to 7.2 mm (0.165 to 0.284 in.)
    C
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)
    K
    2.9 to 5.9 mm (0.114 to 0.232 in.)
    D
    3.0 to 6.0 mm (0.118 to 0.236 in.)
    L
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    E
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)
    M
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    F
    4.2 to 7.2 mm (0.165 to 0.284 in.)
    N
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)
    G
    6.4 to 9.4 mm (0.252 to 0.370 in.)
    O
    3.3 to 6.3 mm (0.130 to 0.248 in.)
    H
    4.2 to 7.2 mm (0.165 to 0.284 in.)
    P
    -1.5 to 1.5 mm (-0.059 to 0.059 in.)