DTC B2284 Brake Signal Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2284 | The brake signal circuit between the main body ECU (instrument panel junction block) and the stop light switch is malfunctioning and the CAN information is inconsistent |
|

| 1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM) |
Delete the DTCs (Click here).
Check for CAN communication system DTCs (Click here).
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT |
Delete the DTCs (Click here).
Check for DTCs again.
Proceed to the next step based on the inspection result.
| Result | Proceed to |
| No DTC is output | A |
| Engine control system DTC is output | B |
| Vehicle stability control system DTC is output | C |
|
| ||||
|
| ||||
| A | |
| 3.READ VALUE USING TECHSTREAM (STOP LIGHT SWITCH) |
Connect Techstream to the DLC3.
Turn the power switch on (IG).
Check the DATA LIST for proper functioning of the stop light switch.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Stop Light SW | Stop light switch/ON or OFF | ON: Brake pedal depressed OFF: Brake pedal released | - |
|
| ||||
| OK | ||
| ||
| 4.CHECK OPERATION OF STOP LIGHT |
Check whether the stop lights turn on and off normally when the brake pedal is depressed and released.
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (STOP LIGHT CONTROL RELAY - INSTRUMENT PANEL JUNCTION BLOCK) |
Disconnect the 1M connector from the instrument panel junction block.

Remove the stop light control relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| IM-7 - Engine room relay block stop light control relay terminal 3 | Always | Below 1 Ω |
| IM-7 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||