ELECTRONICALLY CONTROLLED BRAKE SYSTEM > CALIBRATION |
| DESCRIPTION |
| Part to be Replaced / Operation | Necessary Operation |
| Skid control ECU | Yaw rate and acceleration sensor zero point calibration |
| Yaw rate and acceleration sensor |
|
| Front wheel alignment adjustment |
|
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When Using the Techstream) |
Clear the zero point calibration data.
Turn the power switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in P.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Select the skid control ECU to clear the zero point calibration data using the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Reset Memory.
Turn the power switch off.
Perform the zero point calibration of the yaw rate and acceleration sensor.
Turn the power switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in P.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Switch the skid control ECU to Test Mode using the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode.
After Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights come on for several seconds and then blink in Test Mode.
Turn the power switch off and disconnect the Techstream.
| OBTAIN ZERO POINT OF YAW RATE AND ACCELERATION SENSOR (When not Using the Techstream) |
Clear the zero point calibration data.
Turn the power switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in P.
Turn the power switch on (IG).
The warning light and indicator light come on for 3 seconds to indicate that the initial check is completed.
![]() |
Using SST, connect and disconnect terminals TS and CG of the DLC3 4 times or more within 8 seconds.
Check that no codes other than ABS code 42, VSC code 45 and electronically controlled brake system code 48, 66, or 95 are stored in the diagnostic system.

Perform the zero point calibration of the yaw rate and acceleration sensor.
Turn the power switch off.
Check that the steering wheel is in the straight-ahead position.
Check that the shift lever is in P.
![]() |
Using SST, connect terminals TS and CG of the DLC3.
Turn the power switch on (IG).
After Test Mode has been entered, keep the vehicle stationary on a level surface for 2 seconds or more.
![]() |
Check that the ABS warning, brake warning / yellow (minor malfunction) and slip indicator lights come on for several seconds and then blinks in Test Mode.
Turn the power switch off and disconnect SST from the DLC3.