Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK TIRE PRESSURE WARNING ECU

HINT:
Inspect the connectors from the back side.


E129452E21

  1. Disconnect the D33 tire pressure warning antenna and receiver connector.

  2. Measure the voltage according to the value(s) in the table below.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D33-1 (IG) - D33-7 (GND)
    B - W-B
    IG power source
    Power switch on (IG)
    11 to 14 V
    D33-6 (CANP) - D33-12 (CANN)
    B - W
    CAN communication line
    Power switch on (IG)
    11 to 14 V

  3. Connect the D33 tire pressure warning antenna and receiver connector.

  4. Measure the voltage and resistance according to the value(s) in the table below. If the result is not as specified, the ECU may have a malfunction.

    Symbols (Terminal No.)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D33-10 (RF5V) - D33-7 (GND)
    LG - W-B
    Tire pressure warning antenna and receiver power source
    Power switch on (IG)
    4.5 to 5.5 V
    D33-1 (IG) - D33-7 (GND)
    B - W-B
    IG power source
    Power switch on (IG)
    11 to 14 V
    D33-7 (GND) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    D33-9 (RDA) - D33-7 (GND)
    G - W-B
    Tire pressure warning antenna and receiver signal
    1. Power switch on (IG)
    1. Tire pressure warning antenna and receiver is not connected
    9 to 16 V
    D33-4 (GND2) - D33-7 (GND)
    W - W-B
    Tire pressure warning antenna and receiver ground
    Always
    Below 1 Ω