SMART KEY SYSTEM > CUSTOMIZE PARAMETERS |
| CUSTOMIZING FUNCTION WITH TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus:
Customize Setting. / Smart Key.
Select the setting by referring to the table below.
| Display (Item) | Default | Contents | Setting |
| Ignition Available Area | ALL | Function to choose the available area for electrical key to start engine and release the steering lock. | FRONT / ALL |
| Park Wait Time | 2.5s | Function that sets waiting time to permit opening door after door is locked with entry lock function. | 0.5s / 1.5s / 2.5s / 5.0s |
| Glass Hatch Open Operation | ON | Function to open the glass hatch when the driver has the electrical key and presses glass hatch opener switch. | ON / OFF |
| Back Door Opening Operation | LONG | Function to open the back door when the driver has the electrical key and presses back door opener switch. | LONG / TWICE / OFF |
| Display (Item) | Default | Contents | Setting |
| Passenger Take Key | ON | Function to warn that the electrical key is taken out by passengers (It means that the key is taken out from except the driver's door) when engine is running. | ON / OFF |
| Key Out Range Warning | ON | Function to set a warning function for trying to start the engine before key is still out of its range. | ON / OFF |
| Key Low Battery Warning | ON | Function to set a warning function for the time when a key battery becomes weak. | ON / OFF |
| ENTRY UNLOCK MODE SWITCHING FUNCTION |
To change the vehicle to entry unlock mode switching function:
When the power switch is off, press the LOCK button and one of the other buttons on the key at the same time for approximately 5 seconds while the key is in the actuation area.
The certification ECU (smart key ECU assembly) receives this signal from the door control receiver and switches the entry unlock mode.
The certification ECU (smart key ECU assembly) sounds the wireless door lock buzzer and the buzzer in the combination meter to inform the user that the mode has been switched.
If the entry unlock mode needs to be switched again, press the LOCK button and one of the other three buttons on the key at the same time for approximately 5 seconds after the LED of the key goes off.
The certification ECU (smart key ECU assembly) receives this signal from the door control receiver and changes the smart key system to the entry unlock mode.
The certification ECU (smart key ECU assembly) sounds the wireless door lock buzzer and the buzzer of the combination meter to inform the user that the mode has been switched.

| ELECTRICAL KEY CANCEL |
The operation procedures are as follows:
Precondition:
Power switch off, driver side door closed and unlocked.
Unlock the driver side door once with the UNLOCK switch of the electrical key.
Open the driver door within 5 seconds.
Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.
Close and open the driver door twice within 30 seconds.
(Driver Door: Close → Open → Close → Open)
Unlock the driver side door twice with the UNLOCK switch of the electrical key within 5 seconds.
Close and open the driver door within 30 seconds.
(Driver Door: Close → Open)
Close the driver door within 5 seconds.
When electrical key cancel is activated, the wireless door lock buzzer sounds twice.
To return to the original condition, perform the procedures again. When the original condition is returned, the wireless door lock buzzer sounds once.