STEERING LOCK SYSTEM > Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the D11 connector from the steering lock actuator assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-1 (GND) - Body ground | Always | Below 1 Ω |
| D11-2 (SGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BATTERY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-7 (B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | ||
| ||