Home › ENGINE › 3MZ-FE COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK NO. 1 FAN MAIN RELAY


    A169410
  1. Remove the relay from the engine room No. 1 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 MΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the NO. 1 FAN MAIN relay.

  1. Install the relay to the engine room No. 1 relay block.



2. CHECK NO. 2 FAN MAIN RELAY


    A169410
  1. Remove the relay from the engine room No. 1 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 MΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the NO. 2 FAN MAIN relay.

  1. Install the relay to the engine room No. 1 relay block.