Home › HYBRID SYSTEM · P310 › HYBRID VEHICLE CONTROL › HYBRID CONTROL SYSTEM

DTC    P0AA4-232    Hybrid Battery Negative Contactor Circuit Stuck Closed

for Preparation Click here


DESCRIPTION

Refer to the description for DTC P0AE6-225 .
This circuit uses the hybrid vehicle control ECU to monitor the system main relays and stops the system if a malfunction is detected in the relays, because it may be impossible to shut off the high-voltage system if any of the relays becomes stuck.

DTC No.
INF Code
DTC Detection Condition
Trouble Area
P0AA4
232
SMR3 on the HV battery negative side stuck closed
HV relay assembly

MONITOR DESCRIPTION

The hybrid vehicle control ECU monitors SMR3, because shutting off the high-voltage system might be impossible if the relay terminal becomes stuck. If the hybrid vehicle control ECU detects that the relay terminal has become stuck closed, it will illuminate the MIL and set a DTC.

MONITOR STRATEGY


Related DTCs
P0AA4 (INF 232): negative side stuck
Required sensors / components
SMR3
Frequency of operation
Continuous
Duration
TMC's intellectual property
MIL operation
Immediately
Sequence of operation
None

TYPICAL ENABLING CONDITIONS


The monitor will run whenever the DTCs listed are not present
TMC's intellectual property
Other conditions belong to TMC's intellectual property
-

TYPICAL MALFUNCTION THRESHOLDS


TMC's intellectual property
-

COMPONENT OPERATING RANGE


SMR3
DTC P0AA4 (INF 232) is not detected

WIRING DIAGRAM

See the wiring diagram of P0AE6-225 .

INSPECTION PROCEDURE

CAUTION:
  1. Before inspecting the high-voltage system or disconnecting the low voltage connector of the inverter with converter assembly, take safety precautions such as wearing insulated gloves and removing the service plug grip to prevent electrical shocks. After removing the service plug grip, put it in your pocket to prevent other technicians from accidentally reconnecting it while you are working on the high-voltage system.
  2. After disconnecting the service plug grip, wait for at least 5 minutes before touching any of the high-voltage connectors or terminals. After waiting for 5 minutes, check the voltage at the terminals in the inspection point in the inverter with converter assembly. The voltage should be 0 V before beginning work.

HINT:
Waiting for at least 5 minutes is required to discharge the high-voltage capacitor inside the inverter with converter assembly.

1.CHECK HV RELAY ASSEMBLY

CAUTION:
Be sure to wear insulated gloves.

  1. Turn the power switch off.



    A108056E07
  1. Remove the service plug grip (Click here).

    NOTICE:
    After removing the service plug grip, do not turn the power switch on (READY), unless instructed by the repair manual because this may cause a malfunction.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    z31-1 - j3-1
    Power switch off
    10 kΩ or higher

    HINT:
    1. If a system main relay is stuck closed, inspect the HV relay assembly without removing it from the vehicle, in order to keep the relay closed.
    2. If P0AA4-232 is output, the HV relay assembly must be replaced. Measuring resistance can determine if this is either a present or past malfunction.



NG
REPLACE HV RELAY ASSEMBLY (Click here)
OK

REPLACE HV RELAY ASSEMBLY (Click here)