DTC B1471/71 A/C Inverter High Voltage Power Resource System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1471/71 |
|
|

| 1.CHECK CAN COMMUNICATION SYSTEM |
Using the Techstream, check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.CHECK FOR DTC (HYBRID CONTROL SYSTEM) |
Check if DTCs for the hybrid control system are output using the Techstream.
|
| ||||
| OK | |
| 3.INSPECT ELECTRIC VEHICLE FUSE |
Turn the power switch off.
Remove the service plug grip.
![]() |
Remove the inverter cover assembly.
![]() |
Check that bolts A and B are tightened securely.
Measure the resistance according to the value(s) in the table below.
| Tester Item (Tester Connection) | Condition | Specified Condition |
| ELECTRIC VEHICLE fuse (A - B) | Always | Below 1 Ω |
|
| ||||
| OK | |
| 4.INSPECT INVERTER WITH CONVERTER ASSEMBLY |
![]() |
Disconnect the connector from the inverter with converter assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| B-3 - 1 | Always | Below 1 Ω |
| B-1 - 2 | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.INSPECT NO. 4 ENGINE WIRE |
![]() |
Disconnect the connector from the No. 4 engine wire.
Measure the resistance according to the value(s) in the table below.
| Tester Connection (Symbols) | Condition | Specified Condition |
| i1-1 (-) - i2-1 (-) | Always | Below 1 Ω |
| i1-2 (+) - i2-3 (+) | Always | Below 1 Ω |
| i1-1 (-) - i1-2 (+) | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||