DTC B1476/76 A/C Inverter Load System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1476/76 | Motor rotation load while the compressor is operating is too large or too small. |
|

| 1.CHECK CAN COMMUNICATION SYSTEM |
Using the Techstream, check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the power switch on (IG) and turn the Techstream on.
Select the item below in the Active Test and then check that the fan operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Electrical Fan | Electrical fan | OFF, ON | - |
|
| ||||
| OK | |
| 3.CHECK REFRIGERANT PRESSURE |
Install a manifold gauge set (Click here).
![]() |
Read the manifold gauge pressure when the following conditions are established.
Prepare the vehicle according to the chart below.
| Item | Condition |
| Vehicle doors | All fully open |
| Temperature setting | MAX COLD |
| Blower speed | HI |
| A/C switch | ON |
| R/F switch | RECIRCULATION (30 to 35°C (86 to 95°F)) |
|
| ||||
| OK | ||
| ||