Home › ENGINE › 3MZ-FE STARTING › SMART KEY SYSTEM

SMART KEY SYSTEM > Power Switch Indicator Circuit

for Preparation Click here


DESCRIPTION

Power switch conditions (power source mode) or system malfunctions can be checked by the status of the power switch indicator light.

Power switch indicator light condition: 
Power Source Mode/Condition
Indicator Light Condition
Brake pedal released
Brake pedal depressed, shift lever in P
off
OFF
ON (Green) (When key and vehicle IDs match)
on (ACC, IG)
ON (Amber)
ON (Green)
on (READY)
OFF
OFF
Steering lock not unlocked
Flashes (Green) for 15 sec.
Flashes (Green) for 15 sec.
System malfunction
Flashes (Amber) for 15 sec.
Flashes (Amber) for 15 sec.

WIRING DIAGRAM


B157549E06


INSPECTION PROCEDURE

1.INSPECT POWER SWITCH


  1. Remove the power switch (Click here).


    B138024E06

  1. Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the power switch indicator will not illuminate.
    2. If the voltage is too low, the indicator will not illuminate.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 11 (SWIL)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 12 (INDS)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates
    Battery positive (+) → Terminal 13 (INDW)
    Battery negative (-) → Terminal 4 (COM) or 5 (GND)
    Illuminates



NG
REPLACE POWER SWITCH (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (POWER SWITCH - MAIN BODY ECU AND BODY GROUND)


  1. Disconnect the D25 switch connector.


    B137980E23

  1. Disconnect the D8 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D25-11 (SWIL) - D8-25 (SWIL)
    Always
    Below 1 Ω
    D25-12 (INDS) - D8-15 (INDS)
    Always
    Below 1 Ω
    D25-13 (INDW) - D8-14 (INDW)
    Always
    Below 1 Ω
    D25-5 (GND) - Body ground
    Always
    Below 1 Ω
    D25-4 (COM) - Body ground
    Always
    Below 1 Ω
    D25-11 (SWIL) or D8-25 (SWIL) - Body ground
    Always
    10 kΩ or higher
    D25-12 (INDS) or D8-15 (INDS) - Body ground
    Always
    10 kΩ or higher
    D25-13 (INDW) or D8-14 (INDW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)