DTC B2286 Runnable Signal Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2286 | Serial communication signals and CAN communication signals in the circuit between the main body ECU (instrument panel junction block) and hybrid vehicle control ECU are inconsistent. |
|

| 1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM) |
Delete the DTCs (Click here).
Check for CAN communication system (Click here).
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM |
Connect Techstream to the DLC3.
Check the DATA LIST for proper functioning of the engine.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Ready signal | Hybrid control system start request signal monitor / ON or OFF | ON: Hybrid control system is ON (READY) OFF: Hybrid control system is OFF | - |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - HYBRID VEHICLE CONTROL ECU) |
Disconnect the D35 hybrid vehicle control ECU connector.

Disconnect the D9 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D9-8 (RDY) - D35-12 (RDY) | Always | Below 1 Ω |
| D9-8 (RDY) or D35-12 (RDY) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||