DTC B2788 IG2 Signal Malfunction |
| DTC No. | DTC Detecting Condition | Trouble Area |
| B2788 | Different information is obtained from IG2 signals received directly from the IG2 circuit, and from IG2 signals sent via LIN communication for a period of 1 second. |
|

| 1.INSPECT IGNITION RELAY NO. 2 (IG2) |
![]() |
Remove the IG2 relay from the engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 5 | Always | 10 kΩ or higher |
| 3 - 5 | Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the D11 connector from the steering lock actuator assembly.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-1 (GND) - Body ground | Always | Below 1 Ω |
| D11-2 (SGND) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY - BATTERY) |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D11-6 (IG2) - D11-1 (GND) | Power switch on (IG) | 11 to 14 V |
| D11-6 (IG2) - D11-2 (SGND) | Power switch on (IG) | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| *D11-6 (IG2) - D11-7 (B) | Power switch off | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||