LIGHTING SYSTEM > Headlight Relay Circuit |


| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check the operation.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Headlight Relay | Headlight relay | ON/OFF | - |
|
| ||||
| OK | ||
| ||
| 2.INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the H-LP (LL) fuse and H-LP (RL) fuse from the engine room junction block assembly.
Measure the voltage between the loading slot of each fuse and body ground.
| Tester Connection | Switch Condition | Specified Condition |
| H-LP (LL) fuse terminal - Body ground | Light control switch OFF → HEAD | Below 1 V → 11 to 14 V |
| H-LP (RL) fuse terminal - Body ground | Light control switch OFF → HEAD | Below 1 V → 11 to 14 V |
|
| ||||
| OK | ||
| ||
| 3.INSPECT ENGINE ROOM JUNCTION BLOCK ASSEMBLY |
![]() |
Remove the engine room junction block assembly from the engine room relay block.
Connect the positive (+) lead from the battery to terminal 2G-1
Connect the negative (-) lead from the battery to terminal 2D-8 and 2D-9.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2B-4 - Battery negative | Always | 11 to 14 V |
| 2B-5 - Battery negative | Always | 11 to 14 V |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BATTERY - ENGINE ROOM JUNCTION BLOCK ASSEMBLY) |
![]() |
Disconnect the 2G engine room junction block assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connector | Condition | Specified Condition |
| 2G-1 - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY - MAIN BODY ECU) |
![]() |
Disconnect the 2D engine room junction block assembly connector.
Disconnect the 1D instrument panel junction block connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2D-9 - 1D-3 | Always | Below 1 Ω |
| 2D-9 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (ENGINE ROOM JUNCTION BLOCK ASSEMBLY - BODY GROUND) |
![]() |
Disconnect the 2D engine room junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2D-8 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||