DTC P0571 Brake Switch "A" Circuit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0571 | Voltage of STP terminal and that of ST1- terminal of hybrid vehicle control ECU are less than 1 V for 0.5 sec. or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - BATTERY) |
![]() |
Disconnect the A19 connector from the stop light switch.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-2 - Body ground | Always | 11 to 14 V |
| A19-3 - Body ground | Power switch on (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 2.INSPECT STOP LIGHT SWITCH |
![]() |
Remove the stop light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| 1 - 2 | Switch pin pushed | 10 kΩ or higher |
| 3 - 4 | Switch pin pushed | Below 1 Ω |
Install the stop light switch.
|
| ||||
| OK | |
| 3.CHECK HYBRID VEHICLE CONTROL ECU |
![]() |
Disconnect the D35 connector from the hybrid vehicle control ECU.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D35-31 (STP) - Body ground | Brake pedal is depressed | 11 to 14 V |
| D35-31 (STP) - Body ground | Brake pedal is released | Below 1 V |
| D35-25 (ST1-) - Body ground | Brake pedal is depressed | Below 1 V |
| D35-25 (ST1-) - Body ground | Brake pedal is released | 11 to 14 V |
|
| ||||
| OK | ||
| ||