Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > CUSTOMIZE PARAMETERS


HINT:
The following items can be customized.

NOTICE:
  1. After confirming whether the items requested by the customer are applicable or not for customization, perform customizing operations.
  2. Be sure to record the current settings before customization.
  3. When troubleshooting, make sure that the item in question is not set to "OFF" as a result of customization (Example: For the system, "the wireless function does not operate", first check that the wireless function is not set to "OFF", then perform troubleshooting).


CUSTOMIZE
  1. Connect Techstream to the DLC3.

  2. Turn the power switch on (IG).

  3. Turn the tester on.

  4. Enter the following menus:
    Select: Customize Setting /

  5. Select the setting by referring to the table below.


Security: 
Display (Item)
Default
Contents
Setting
Passive Mode
OFF
  1. Passive Mode is a function that switches the theft deterrent system from the arming preparation state to the armed state 30 seconds after the key is removed from the actuation area and all doors, glass hatch* and engine hood are closed, even if the doors are not locked by wireless or door key lock operation.
  2. In Passive Mode, if the following operations are not performed within 14 seconds after a door is opened during armed state, the theft deterrent system will judge that condition as a theft and switch to the alarm sounding state.
    1. Unlock any door by key or wireless operation
    2. Turn the power switch on (IG)
ON/OFF
Warning by Horn
ON
Function that allows the vehicle horn and theft deterrent horn to be used as warning devices.
ON/OFF
Entry Delay Time
14 s
Function that changes entry delay time (time before warning starts) for Passive Mode
0 s/14 s/30 s

HINT:
*: w/ Glass Hatch Opener System