Home › SUSPENSION & AXLE › SUSPENSION › FRONT LOWER SUSPENSION ARM

FRONT LOWER SUSPENSION ARM > INSTALLATION

for Preparation Click here



1. INSTALL FRONT LOWER SUSPENSION ARM
  1. Install the front lower arm bushing stopper to the front lower suspension arm.

  1. Install the front lower suspension arm to the front frame assembly with the 3 bolts and nut, but do not tighten them yet.



    C167143E01
  1. Tighten the 3 bolts in numerical order shown in the illustration.

    Torque:
    Bolt 1, 2:
    200 N*m{ 2039 kgf*cm , 147 ft.*lbf }
    Bolt 3:
    206 N*m{ 2100 kgf*cm , 152 ft.*lbf }

    HINT:
    Tighten the bolts starting from the front side of the vehicle.



2. INSTALL REAR ENGINE MOUNTING INSULATOR


    A171844
  1. Install the rear engine mounting insulator with the 2 nuts.

    Torque:
    52 N*m{ 531 kgf*cm , 39 ft.*lbf }



    A171843
  1. Install the 2 hole plugs.



3. INSTALL FRONT FRAME ASSEMBLY


  1. Temporarily install the engine assembly with transaxle with the 9 nuts.


    A172973E01



    C179023
  1. Connect the rear engine mounting insulator with the 2 bolts.

    Torque:
    75 N*m{ 765 kgf*cm , 55 ft.*lbf }



  1. Fully tighten the 9 nuts.


    A172973E02

    Torque:
    Nut A:
    52 N*m{ 531 kgf*cm , 39 ft.*lbf }
    Nut B:
    87 N*m{ 888 kgf*cm , 65 ft.*lbf }



  1. Install the 5 hole plugs.


    A172972E01



4. INSTALL POWER STEERING LINK ASSEMBLY


    C174974
  1. Install the power steering link assembly with the 2 bolts and 2 nuts.

    Torque:
    70 N*m{ 713 kgf*cm , 51 ft.*lbf }

    NOTICE:
    1. Make sure to tighten the bolts starting from the left side of the vehicle.
    2. Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.



5. INSTALL FRONT STABILIZER BAR WITH FRONT STABILIZER LINK ASSEMBLY


6. INSTALL NO. 1 FRONT STABILIZER BRACKET LH


    C167140
  1. Install the No. 1 front stabilizer bracket LH to the front frame assembly with the 2 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



7. INSTALL NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



8. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Install the engine assembly with transaxle (Click here).



9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
Inspect and adjust front wheel alignment (Click here).