FRONT LOWER BALL JOINT > REMOVAL |
| 1. REMOVE FRONT WHEEL |
| 2. REMOVE FRONT AXLE HUB NUT |
![]() |
Using SST and a hammer, release the staked part of the front axle shaft nut LH.
While applying the brakes, remove the front axle shaft nut LH.
| 3. SEPARATE FRONT SPEED SENSOR |
![]() |
Remove the bolt and resin clamp, and separate the front speed sensor.
| 4. SEPARATE FRONT DRIVE SHAFT ASSEMBLY |
![]() |
Put matchmarks on the front drive shaft assembly and the front axle hub sub-assembly.
![]() |
Using a plastic hammer, separate the front drive shaft assembly from the front axle assembly.
| 5. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the 2 bolts and separate the front disc brake caliper assembly.
| 6. REMOVE FRONT DISC |
![]() |
Remove the front disc.
| 7. SEPARATE TIE ROD ASSEMBLY |
Remove the cotter pin and the nut.
![]() |
Install SST to the tie rod end.
Using SST, separate the tie rod end from the steering knuckle.

| 8. SEPARATE FRONT LOWER SUSPENSION ARM |
![]() |
Remove the bolt and 2 nuts, and separate the front lower suspension arm from the lower ball joint.
| 9. REMOVE FRONT AXLE ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts and front axle assembly.
| 10. REMOVE FRONT LOWER BALL JOINT |
![]() |
Secure the front axle assembly in a vise using aluminum plates.
![]() |
Remove the cotter pin and nut.
![]() |
Install SST to the front lower ball joint as shown in the illustration.
![]() |
Using SST, remove the front lower ball joint from the front axle assembly as shown in the illustration.