Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR

FRONT STABILIZER BAR > INSTALLATION

for Preparation Click here



1. INSTALL NO. 1 FRONT STABILIZER BAR BUSHING


    C167142E02
  1. Install the 2 No. 1 front stabilizer bar bushings to the front stabilizer bar as shown in the illustration.

    NOTICE:
    Install the No. 1 front stabilizer bar bushings so that the cutout faces the rear of the vehicle.



2. INSTALL NO. 2 FRONT STABILIZER BRACKET LH


    C167141
  1. Install the No. 2 front stabilizer bracket LH to the No. 1 front stabilizer bar bushing.



3. INSTALL NO. 2 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



4. INSTALL FRONT STABILIZER BAR
  1. Install the front stabilizer bar by inserting it from the right side of the vehicle.



5. INSTALL NO. 1 FRONT STABILIZER BRACKET LH


    C167140
  1. Install the No. 1 front stabilizer bracket LH to the front frame assembly with the 2 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }



6. INSTALL NO. 1 FRONT STABILIZER BRACKET RH

HINT:
Perform the same procedure as the LH side.



7. INSTALL FRONT STABILIZER LINK ASSEMBLY LH


    C167139
  1. Install the front stabilizer link assembly LH with the nut.

    Torque:
    74 N*m{ 755 kgf*cm , 55 ft.*lbf }

    HINT:
    If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud bolt.



8. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure as the LH side.



9. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE

HINT:
Install the engine assembly with transaxle (Click here).



10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

HINT:
Inspect and adjust front wheel alignment (Click here).