Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER

REAR SHOCK ABSORBER > DISPOSAL

for Preparation Click here



1. DISPOSE OF REAR SHOCK ABSORBER


    C113132E02
  1. Fully extend the shock absorber piston rod.

  1. Using a drill, make a hole in area B shown in the illustration to discharge the gas inside.

    Length (A):
    25 mm (0.98 in.)

    Length (B):
    25 mm (0.98 in.)

    CAUTION:
    1. Be careful when drilling because shards of metal may fly about. Always use proper safety equipment.
    2. The gas is colorless, odorless and non-poisonous.