SEAT HEATER SWITCH > INSPECTION |
| 1. INSPECT SEAT HEATER SWITCH |
![]() |
Inspect the driver side seat heater switch operation.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 3 (IG) - 5 (SW) | OFF | 10 kΩ or higher |
| 3 (IG) - 5 (SW) | ON | Below 1 Ω |
| 4 (RV) - 5 (SW) | ON (Minimum to Maximum) | 0.35 to 3.4 kΩ |
Turn the seat heater switch on and check if the seat heater switch indicator comes on.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 3 (IG) Battery negative (-) → Terminal 9 (E) | Comes on |
![]() |
Inspect the front passenger side seat heater switch operation.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Position | Specified Condition |
| 3 (IG) - 8 (SW) | OFF | 10 kΩ or higher |
| 3 (IG) - 8 (SW) | ON | Below 1 Ω |
| 2 (RV) - 8 (SW) | ON (Minimum to Maximum) | 0.35 to 3.4 kΩ |
Turn the seat heater switch on and check if the seat heater switch indicator comes on.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 3 (IG) Battery negative (-) → Terminal 9 (E) | Comes on |
Check if the seat heater switch indicator comes on.

| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 10 (ILL+) Battery negative (-) → Terminal 6 (ILL-) | Comes on |