Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > IG Signal Circuit

for Preparation Click here


DESCRIPTION

  1. The main body ECU receives IG signal to control the following systems:
    1. Automatic light control system
    2. Light auto turn-off system
    3. Daytime running light system
    4. Illuminated entry system

WIRING DIAGRAM


E136353E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the Power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. Read the display on the Techstream.

    Main Body: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    IG SW
    Power switch IG signal / ON or OFF
    ON: Power switch on (IG)
    OFF: Power switch off
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT FUSE (ECU-IG NO. 1)
  1. Remove the ECU-IG No. 1 fuse from the instrument panel junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


3.CHECK HARNESS AND CONNECTOR (IG POWER SOURCE CIRCUIT)


    E142680E01
  1. Measure the voltage between the loading slot of the fuse and body ground.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    ECU-IG No. 1 fuse terminal - Body ground
    Power switch off
    Below 1 V
    Power switch on (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK)