Home › ENGINE › 3MZ-FE ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REPLACEMENT

for Preparation Click here



1. REMOVE VALVE GUIDE BUSH


    A005234E01
  1. Heat the cylinder head to 80 to 100°C (176 to 212°F).



    A181920E01
  1. Using SST and a hammer, tap out the guide bush.

    SST
    09201-10000   (09201-01055)
    09950-70010   (09951-07100)



2. INSTALL VALVE GUIDE BUSH


    P012956E01
  1. Using a caliper gauge, measure the bush bore diameter of the cylinder head.

    Diameter:
    10.295 to 10.313 mm (0.4053 to 0.4060 in.)

    If the bush bore diameter of the cylinder head is greater than 10.313 mm (0.4060 in.), machine the bush bore to the dimension of 10.345 to 10.363 mm (0.4073 to 0.4080 in.).

    HINT:
    Using a caliper gauge, measure the cylinder head.

    Bush diameter:

    Bush diameter
    STD
    10.333 to 10.344 mm (0.4068 to 0.4072 in.)
    O/S
    10.383 to 10.394 mm (0.4088 to 0.4092 in.)



    A080660E04
  1. Using vernier calipers, measure the new bush length.

    HINT:
    Using vernier calipers, measure the bush.

    Bush length:

    Bush length
    Intake
    34.5 mm (1.358 in.)
    Exhaust
    40.5 mm (1.594 in.)



    A005234E01
  1. Heat the cylinder head to 80 to 100°C (176 to 212°F).



    A078778E01
  1. Using SST and a hammer, tap in a new guide bush to the specified protrusion height.

    SST
    09201-10000   (09201-01055)
    09950-70010   (09951-07100)

    Protrusion height:

    Bush length
    Intake
    11.1 to 11.5 mm (0.437 to 0.453 in.)
    Exhaust
    8.9 to 9.3 mm (0.350 to 0.366 in.)



    Z009124E01
  1. Using a sharp 5.5 mm reamer, ream the guide bush to obtain the standard specified clearance between the guide bush and the valve stem.

    Standard oil clearance:

    Bush length
    Intake
    0.025 to 0.060 mm (0.0010 to 0.0024 in.)
    Exhaust
    0.030 to 0.065 mm (0.0012 to 0.0026 in.)