Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY


    B181907E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    for LH:
    Tester Connection
    Condition
    Specified Condition
    O10-1 - O10-3
    Seat belt is unfastened
    Below 1 Ω
    O10-1 - O10-3
    Seat belt is fastened
    1 MΩ or higher
    for RH:
    Tester Connection
    Condition
    Specified Condition
    a5-1 - a5-2
    Seat belt is unfastened
    Below 1 Ω
    a5-1 - a5-2
    Seat belt is fastened
    1 MΩ or higher

    If the result is not as specified, replace the inner belt assembly.