Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Radio Receiver Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the radio receiver.

WIRING DIAGRAM


E153641E02


INSPECTION PROCEDURE

1.INSPECT RADIO RECEIVER


    E138283E04
  1. Disconnect the radio receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-20 (GND) - Body ground (*1)
    Always
    Below 1 Ω
    E14-14 (GND) - Body ground (*1)
    Always
    Below 1 Ω
    E8-7 (GND) - Body ground (*2)
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E2-1 (B) - E2-20 (GND) (*1)
    Always
    11 to 14 V
    E14-5 (+B) - E14-14 (GND) (*1)
    Always
    11 to 14 V
    E8-4 (B) - E8-7 (GND) (*2)
    Always
    11 to 14 V
    E2-11 (ACC) - E2-20 (GND) (*1)
    Power switch on (ACC)
    11 to 14 V
    E14-16 (ACC) - E14-14 (GND) (*1)
    Power switch on (ACC)
    11 to 14 V
    E8-3 (ACC) - E8-7 (GND) (*2)
    Power switch on (ACC)
    11 to 14 V

    HINT:
    1. *1: for Premium models
    2. *2: for Standard models



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)