Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > DATA LIST / ACTIVE TEST

for Preparation Click here



Data List
Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
  1. Warm up the engine.

  2. Power switch off.

  3. Connect Techstream to the DLC3.

  4. Power switch on (READY).

  5. Turn the tester on.

  6. Enter the following menus:

    1. for Combination Meter: Body Electrical / Combination Meter / Data List.

    2. for ABS/TRAC/VSC: Chassis / ABS/VSC/TRAC / Data List.

    3. for Hybrid Control: Powertrain / Hybrid Control / Data List.

    4. for Main Body: Body Electrical / Main Body / Data List.

  7. Check values by referring to the table below.

    Combination Meter: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Tail Cancel SW
    Tail cancel switch is OFF/ON
    OFF: Turn the light control rheostat knob is not fully downwards
    -
    ON: Turn the light control rheostat knob fully upwards
    -
    ODO/TRIP Change SW
    ODO/TRIP switch is OFF/ON
    OFF: Switch is released
    -
    ON: Switch is pushed
    -
    Vehicle Speed Meter
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Engine Rpm
    Engine speed/Min.: 0 rpm, Max.: 12750 rpm
    Almost same as actual engine speed (When engine is running)
    -
    Coolant Temperature
    Engine coolant temperature: 0°C (32°F) to 127.5°C (261.5°F)
    After warming up: 80 to 95°C (176 to 203°F)
    -
    Washer Switch
    Washer level switch is OFF/ON
    OFF: Washer level is not low
    -
    ON: Washer level is low
    -
    Multi Display Select Switch
    DISP switch in the steering pad is OFF/ON
    OFF: DISP switch is OFF
    -
    ON: DISP switch is ON
    -
    +B Voltage Value
    Battery voltage/Min.: 0 V, Max.: 25.5 V
    11 to 14 V
    -
    Integrated value for Oil Maintenance (*1)
    Oil maintenance warning value: Min.: 0, Max. 25500 (mile)
    The driving distance after performing the oil maintenance resetting procedure is displayed
    If the value is 5000 (miles) or more, perform the oil maintenance resetting procedure after changing the oil
    Power Meter
    Power meter gauge input signal: Min.: -100, Max.: 410 (kW)
    Power meter gauge indicates the value(s) according to the received data
    -
    Fuel Input
    Fuel input signal: Min.: 0, Max.: 127.5
    Fuel gauge indicates (E): 6.8 (L)
    -
    Fuel gauge indicates (1/2): 32.4 (L)
    -
    Fuel gauge indicates (F): 58.3 (L)
    -
    Ambient Temperature
    Outside temperature: Min.: -40°C (-40°F) to 50°C (122°F)
    Almost same as actual outside temperature
    The temperature displayed on the multi-information display is -40 to 50°C (-40 to 122°F)
    Rheostat value
    Light Control Rheostat/Min.: 0%, Max.: 100%
    Light control rheostat switch is Dark (0%) → Bright (100%)
    -
    Quantity of Outside Light
    Quantity of outside light/Min.: 0%, Max.: 100%
    Outside light is Dark (0%) → Bright (100%)
    -
    Key Remind Sound
    The cycle of the key reminder warning buzzer is displayed
    The customized setting of the cycle of the key reminder warning buzzer is displayed
    -
    Key Remind Volume
    The volume of the key reminder warning buzzer is displayed
    The customized setting of the volume of the key reminder warning buzzer is displayed
    -
    Driver Side Seatbelt Warning Buzzer
    The condition of the driver side seat belt warning buzzer
    The customized setting of the driver side seat belt warning buzzer is displayed
    ON: The driver side seat belt warning buzzer sounds when the vehicle speed is 20 km/h (12 mph) or more when the driver side seat belt is unfastened
    OFF: The driver side seat belt warning buzzer does not sound when the vehicle speed is 20 km/h (12 mph) or more when the driver side seat belt is unfastened
    P-seatbelt Warning Buzzer
    The condition of the front passenger side seat belt warning buzzer
    The customized setting of the front passenger side seat belt warning buzzer is displayed
    ON: The front passenger side seat belt warning buzzer sounds when the vehicle speed is 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened
    OFF: The front passenger side seat belt warning buzzer does not sound when the vehicle speed is 20 km/h (12 mph) or more when the front passenger side seat belt is unfastened
    Units By Region
    The type of the unit in the multi-information display
    The customized setting of the multi-information display unit is displayed
    -
    Language
    The type of the language in the multi-information display
    The customized setting of the multi-information display language is displayed
    -
    ECO Drive Indicator
    The condition of the hybrid system indicator
    The customized setting of the hybrid system indicator is displayed
    ON: The hybrid system indicator is displayed when the vehicle speed is 4 km/h (3 mph) or more
    OFF: The hybrid system indicator is not displayed even when the vehicle is driven
    Number of Trouble Code
    The number of the DTC which is currently output
    0
    -
    *1: for U.S.A.
    *2: for Canada

    ABS/VSC/TRAC: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    FL Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    RR Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    RL Wheel Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -
    Vehicle Speed
    Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph)
    Almost same as actual vehicle speed (When driving)
    -

    Hybrid Control: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Coolant Temp
    Engine coolant temperature: Min.: -40°C (-40°F), Max: 140°C (284°F)
    80 to 100°C (176 to 212°F): After warming up
    1. If -40°C (-40°F) or less: sensor circuit open
    2. If 140°C (284°F) or more: sensor circuit shorted
    Engine Revolution
    Vehicle speed/Min.: 0 rpm, Max.: 16383.75 rpm
    Almost same as actual engine speed (When engine running)
    -


Active Test
Using Techstream to perform Active Tests allows the relay, actuator, and other items to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Test early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Test.
  1. Connect Techstream to the DLC3.

  2. Power switch on (READY).

  3. Turn the tester on.

  4. Enter the following menus:

    1. for Combination Meter: Body Electrical / Combination Meter / Active Test.

    2. for Main Body: Body Electrical / Main Body/ Active Test.

  5. Check the operation by referring to the table below.

    Combination Meter: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Speed Meter Operation
    Speedometer
    0, 40, 80, 120 mph (*1)
    Confirm that the vehicle is stopped, engine idling
    0, 40, 80, 120, 160, 200, 240 km/h (*2)
    Fuel Meter Operation
    Fuel receiver gauge
    EMPTY, 1/2, FULL
    Confirm that the vehicle is stopped, engine idling
    Power Meter Operation
    Power meter
    0, 50, 100, 150, 200, MAX (kW)
    Confirm that the vehicle is stopped, engine idling
    A/T Indicator Operation 1
    Hybrid vehicle shift indicator light
    Hybrid vehicle shift indicator light D, N, R, P is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    A/T Indicator Operation 2
    Hybrid vehicle gear range indicator light
    Hybrid vehicle gear range indicator light B is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Meter Display 1
    Multi-information display
    6, 5, 4, 3, 2, 1, 0 is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Meter Display 2
    Hybrid vehicle shift indicator display
    9, 8, 7 is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Airbag
    Airbag warning light
    SRS warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Doors All Open
    Open door warning light
    Open door warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Front Passenger Side Seat Belt
    Front passenger side seat belt warning light
    Front passenger side seat belt warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Driver Side Seat Belt
    Driver side seat belt warning light
    Driver side seat belt warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp ABS
    ABS warning light
    ABS warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Charge
    Charge warning light
    Charge warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Slip
    Slip indicator light
    Slip indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Beam
    Hi-beam indicator light
    Hi-beam indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Head (*1)
    Head indicator light
    Head indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Tail (*2)
    Tail indicator light
    Tail indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Fr FOG
    Front fog indicator light
    Front fog indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Fuel
    Low fuel warning light
    Fuel level warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Tire Pressure Warning System
    Tire pressure warning light
    Tire pressure warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp ECB
    ECB warning light
    ECB warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. ECONO
    ECO Indicator light
    ECO indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Cruise
    Cruise indicator light
    Cruise indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Lamp Brake
    Brake warning light
    Brake warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. EPS
    EPS warning light
    EPS warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. ECO
    Variable economy zone display
    Variable economy zone display is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Master Warning
    Master caution indicator light
    Master caution indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. Ready (HV)
    Ready indicator light
    Ready indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Indicat. EV Mode
    EV MODE indicator light
    EV mode indicator light is OFF/ON
    Confirm that the vehicle is stopped, engine idling
    Water Temperature Meter Operation
    Engine coolant temperature receiver gauge
    Low, Normal, High
    Confirm that the vehicle is stopped, engine idling
    *1: for U.S.A.
    *2: except for U.S.A.

    Main Body: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Dimmer signal
    Dimmer signal
    Dimmer signal is OFF/ON
    OFF: The meter illumination (warning and indicator lights) will not dim even if the light control switch to the TAIL or HEAD position
    ON: The meter illumination (warning and indicator lights) dim when the light control switch to the TAIL or HEAD position