OIL PUMP > INSPECTION |
| 1. INSPECT OIL PUMP RELIEF VALVE |
Apply a light coat of engine oil.
![]() |
Check that it falls smoothly into the valve hole by its own weight.
If the valve does not fall smoothly, replace the relief valve. If necessary, replace the oil pump assembly.
| 2. INSPECT OIL PUMP ASSEMBLY |
Inspect the oil pump rotor set.
Apply a light coat of engine oil to the oil pump rotor set and place it into the oil pump body. Check that the rotors revolve smoothly.
![]() |
Inspect rotor tip clearance.
Using a feeler gauge, measure the clearance between the drive and the driven rotor tips.
![]() |
Inspect rotor body clearance.
Using a feeler gauge, measure the clearance between the driven rotor and body.
![]() |
Inspect rotor side clearance.
Using a feeler gauge and precision straight edge, measure the clearance between the rotors and precision straight edge.