Home › ENGINE › 3MZ-FE LUBRICATION › OIL AND OIL FILTER

OIL AND OIL FILTER > REPLACEMENT

for Preparation Click here


CAUTION:
  1. Prolonged and repeated contact with engine oil will cause removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
  2. Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use a waterless hand cleaner to remove any used engine oil. Do not use gasoline, thinners or solvents.
  3. For environmental protection, used oil and used oil filters must be disposed of at designated disposal sites.



1. REMOVE COOL AIR INTAKE DUCT SEAL
  1. Remove the 11 clips and cool air intake duct seal.



2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A175875
  1. Remove the 2 bolts, 4 clamps and air cleaner cap sub-assembly.

  1. Remove the air cleaner filter element from the air cleaner case.



3. DRAIN ENGINE OIL
  1. Remove the oil filler cap.

  1. Remove the oil drain plug and drain the oil into a container.

  1. Clean and install the oil pan drain plug with a new gasket.

    Torque:
    45 N*m{ 459 kgf*cm , 33 ft.*lbf }



4. REMOVE OIL FILTER
  1. Using SST, remove the oil filter.

    SST
    09228-07501  



5. INSTALL OIL FILTER
  1. Check and clean the oil filter installation surface.

  1. Apply clean engine oil to the gasket of a new oil filter.

  1. Lightly screw the oil filter into place, and tighten it until the gasket contacts the seat.

  1. Using SST, tighten the oil filter.

    SST
    09228-07501  
    Depending on the work space available, choose from the following:

    1. If enough space is available, use a torque wrench to tighten the oil filter.

      Torque:
      18 N*m{ 180 kgf*cm , 13 ft.*lbf }

    2. If enough space is not available to use a torque wrench, tighten the oil filter a 3/4 turn by hand or use a common wrench.



6. ADD ENGINE OIL
  1. Add new oil.

    Engine oil:
    Oil Grade
    Oil Viscosity (SAE)
    ILSAC multigrade engine oil
    1. 5W-20
    2. 0W-20

    Specification:
    Item
    Capacity
    Drain and refill
    with oil filter change
    4.7 liters (5.0 US qts, 4.1 lmp. qts)
    Drain and refill
    without oil filter change
    4.5 liters (4.8 US qts, 4.0 lmp. qts)
    Dry fill
    5.5 liters (5.8 US qts, 4.8 lmp. qts)



7. INSPECT FOR OIL LEAK


8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner filter element to the air cleaner case.



    A175875
  1. Install the 2 bolts, 4 clamps and air cleaner cap sub-assembly.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



9. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 11 clips.