Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › VVT SENSOR

VVT SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL VVT SENSOR (for Bank 1)


    A079541E02
  1. Apply a light coat of engine oil to the O-ring on the VVT sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the VVT sensor connector.



2. INSTALL VVT SENSOR (for Bank 2)


    A078529E02
  1. Apply a light coat of engine oil to the O-ring on the VVT sensor.

  1. Install the VVT sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the VVT sensor connector.



    A108296E02
  1. Install the heated oxygen sensor connector (Bank 2) to the wire harness bracket.



3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
  1. Install the air cleaner filter element to the air cleaner case sub-assembly.



    A173489
  1. Install the air cleaner cap sub-assembly with the 4 clamps and 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }



4. INSTALL NO. 2 ENGINE ROOM SIDE COVER LH


    A173813
  1. Fit the clips and install the No. 2 engine room side cover LH.

    NOTICE:
    1. Be sure to engage the clips securely.
    2. Do not apply excessive force or do not hit the cover to engage the clips. This may cause the cover to break.



5. INSTALL COOL AIR INTAKE DUCT SEAL
  1. Install the cool air intake duct seal with the 11 clips.