Home
›
ENGINE
›
3MZ-FE ENGINE CONTROL SYSTEM
›
VVT SENSOR
VVT SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT VVT SENSOR
Using an ohmmeter, measure the resistance according to the value(s) in the table below.
Standard resistance :
Tester Connection
Condition
Specified Condition
1 - 2
Cold
835 to 1400 Ω
Hot
1060 to 1645 Ω
HINT:
"Cold" and "Hot" refer to the temperature of the coils themselves.
"Cold" is from -10°C (14°F) to 50°C (122°F) and "Hot" is from 50°C (122°F) to 100°C (212°F).
If the resistance is not as specified, replace the sensor.