Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › VVT SENSOR

VVT SENSOR > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL
  1. Remove the 11 clips and cool air intake duct seal.



2. REMOVE NO. 2 ENGINE ROOM SIDE COVER LH


    A173813
  1. Remove the engine room side cover.



3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY


    A173489
  1. Remove the 2 bolts, 4 clamps and air cleaner cap sub-assembly.

  1. Remove the air cleaner filter element from the air cleaner case sub-assembly.



4. REMOVE VVT SENSOR (for Bank 1)


    A079541E02
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt, and then remove the VVT sensor.



5. REMOVE VVT SENSOR (for Bank 2)


    A108296E02
  1. Disconnect the heated oxygen sensor connector (Bank 2) from the wire harness bracket.



    A078529E02
  1. Disconnect the VVT sensor connector.

  1. Remove the bolt, and then remove the VVT sensor.