Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.



    A079763
  1. Install the crankshaft position sensor with the bolt.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf }

  1. Connect the crankshaft position sensor connector.



2. INSTALL FRONT FENDER APRON SEAL RH


3. INSTALL FRONT FENDER LINER RH


4. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the 6 bolts, 2 screws, 2 clips and No. 1 engine under cover.