Home
›
ENGINE
›
3MZ-FE ENGINE CONTROL SYSTEM
›
CRANKSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT CRANKSHAFT POSITION SENSOR
Using an ohmmeter, measure the resistance between the terminals.
Standard resistance:
Tester Connection
Condition
Specified Condition
1 - 2
Cold
1630 to 2740 Ω
Hot
2065 to 3225 Ω
HINT:
"Cold" and "Hot" refer to the temperature of the coils themselves.
"Cold" is from -10°C (14°F) to 50°C (122°F) and "Hot" is from 50°C (122°F) to 100°C (212°F).
If the resistance is not as specified, replace the sensor.