Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 6 bolts, 2 screws, 2 clips and No. 1 engine under cover.



2. SEPARATE FRONT FENDER LINER RH


3. REMOVE FRONT FENDER APRON SEAL RH


4. REMOVE CRANKSHAFT POSITION SENSOR


    A079763
  1. Disconnect the crankshaft position sensor connector.

  1. Remove the bolt, and then remove the crankshaft position sensor.