Home › ENGINE › 3MZ-FE EMISSION CONTROL › CANISTER

CANISTER > INSTALLATION

for Preparation Click here



1. INSTALL CHARCOAL CANISTER ASSEMBLY


    A175994
  1. Install the charcoal canister assembly with the 4 bolts and a new clip.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    A175991
  1. Install the rear engine service cover assembly with the 2 bolts.

    Torque:
    13 N*m{ 130 kgf*cm , 9 in.*lbf }



    A175992
  1. Install the wire harness bracket with the bolt.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



    A175993
  1. Connect the air filter hose.



    A175990
  1. Connect the hose, hose clamp, 2 wire harness clamps and connector.



2. CONNECT CHARCOAL CANISTER FUEL HOSE


    A112499E02
  1. Align the quick connector with the pipe, then push in the quick connector until the retainer makes a "click" sound to connect the charcoal canister fuel hose to the charcoal canister assembly.

    NOTICE:
    1. Check that there are no scratches or foreign objects around the connected part of the quick connector and pipe before this work.
    2. After connecting the charcoal canister fuel hose, confirm that it is securely connected by pulling the quick connector.



3. INSTALL FRONT CENTER FLOOR COVER


4. INSTALL FRONT FLOOR COVER LH