Home › ENGINE › 3MZ-FE EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE FRONT FLOOR COVER LH


2. REMOVE FRONT CENTER FLOOR COVER


3. DISCONNECT CHARCOAL CANISTER FUEL HOSE


    A175989E01
  1. Disconnect the charcoal canister fuel hose from the charcoal canister assembly.

    1. Pinch the retainer and pull out the quick connector with the quick connector pushed to the pipe to disconnect the charcoal canister fuel hose from the charcoal canister assembly.

      NOTICE:
      1. Remove dirt or foreign objects on the quick connector before this work.
      2. Do not to allow any scratches or foreign objects on the parts when disconnecting as the fuel hose connector has an O-ring that seals the pipe.
      3. Perform this work by hand. Do not use any tools.
      4. Do not forcibly bend, twist or turn the nylon tube.
      5. Protect the connected part by covering it with a vinyl bag after disconnecting the charcoal canister fuel hose.
      6. If the quick connector and pipe are stuck, push and pull them to release.



4. REMOVE CHARCOAL CANISTER ASSEMBLY


    A175990
  1. Disconnect the hose clamp, hose, 2 wire harness clamps and connector.



    A175993
  1. Disconnect the air filter hose.



    A175992
  1. Remove the bolt and then disconnect the wire harness bracket.



    A175991
  1. Remove the 2 bolts and rear engine service cover assembly.



    A175994
  1. Remove the 4 bolts, clip and charcoal canister assembly.