Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL OXYGEN SENSOR (for Bank 1)
  1. Temporarily tighten the oxygen sensor to the front No. 3 exhaust pipe sub-assembly.

    NOTICE:
    Do not damage the oxygen sensor.



    A173497E01
  1. Using SST, fully tighten the oxygen sensor to the front No. 3 exhaust pipe sub-assembly.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf } for use without SST
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and the wrench are connected in a straight line.

  1. Connect the oxygen sensor connector and clamp.



2. INSTALL OXYGEN SENSOR (for Bank 2)
  1. Temporarily tighten the oxygen sensor to the front exhaust pipe sub-assembly.

    NOTICE:
    Do not damage the oxygen sensor.



    A173495E01
  1. Using SST, fully tighten the oxygen sensor to the front exhaust pipe sub-assembly.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 33 ft.*lbf } for use without SST
    40 N*m{ 408 kgf*cm , 30 ft.*lbf } for use with SST

    HINT:
    1. Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
    2. Make sure that SST and the wrench are connected in a straight line.

  1. Connect the oxygen sensor connector.