Home › ENGINE › 3MZ-FE ENGINE CONTROL SYSTEM › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > REMOVAL

for Preparation Click here



1. REMOVE OXYGEN SENSOR (for Bank 1)
  1. Disconnect the oxygen sensor connector and clamp.



    A173496E01
  1. Using SST, remove the oxygen sensor from the front No. 3 exhaust pipe sub-assembly.

    SST
    09224-00010  

    NOTICE:
    Do not damage the oxygen sensor.



2. REMOVE OXYGEN SENSOR (for Bank 2)
  1. Disconnect the oxygen sensor connector.



    A173494E01
  1. Using SST, remove the oxygen sensor from the front exhaust pipe sub-assembly.

    SST
    09224-00010  

    NOTICE:
    Do not damage the oxygen sensor.