Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > DISASSEMBLY

for Preparation Click here



1. REMOVE BRAKE STROKE SIMULATOR BRACKET


    C140624
  1. Disconnect the connector.

  1. Remove the 2 bolts and brake stroke simulator bracket from the brake stroke simulator cylinder sub-assembly.



2. REMOVE MASTER CYLINDER PUSH ROD CLEVIS


    C170604
  1. Loosen the lock nut, and remove the master cylinder push rod clevis and lock nut.

    HINT:
    If the protrusion of the push rod in relation to the push rod clevis is measured beforehand, it is easier to perform the brake pedal height adjustment after the brake master cylinder sub-assembly is installed.



3. REMOVE MASTER CYLINDER RESERVOIR GROMMET


    C170603
  1. Remove the screw and brake master cylinder union.

  1. Remove the 2 master cylinder reservoir grommets from the brake master cylinder union.