Home › BRAKE › BRAKE › BRAKE MASTER CYLINDER

BRAKE MASTER CYLINDER > REASSEMBLY

for Preparation Click here



1. INSTALL MASTER CYLINDER RESERVOIR GROMMET


    C170603E01
  1. Apply lithium soap base glycol grease to 2 new master cylinder reservoir grommets.

  1. Install the 2 master cylinder reservoir grommets to the brake master cylinder union.

  1. Install the brake master cylinder union to the brake master cylinder sub-assembly with the screw.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }



2. INSTALL MASTER CYLINDER PUSH ROD CLEVIS


    C170604
  1. Temporarily install the lock nut and master cylinder push rod clevis to the brake master cylinder sub-assembly.

    HINT:
    Completely install the lock nut and master cylinder push rod clevis when adjusting the brake pedal height.



3. INSTALL BRAKE STROKE SIMULATOR BRACKET


    C140624
  1. Install the brake stroke simulator bracket to the brake stroke simulator cylinder sub-assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the connector to the brake stroke simulator bracket.