Home › BODY › WINDSHIELD / WINDOWGLASS › GLASS HATCH OPENER SYSTEM

GLASS HATCH OPENER SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU


  1. Disconnect the 1A, 1D and 1F Junction block connectors.


    B150879E05

  2. Measure the voltage and resistance between the specified terminals of the wire harness side connectors and body ground.

    Standard voltage:

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1A-1 - Body ground
    B - Body ground
    Battery power supply
    Always
    11 to 14 V
    1D-16 (ALTB) - Body ground
    W - Body ground
    Generator power supply
    Always
    11 to 14 V


    Standard resistance:

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    1F-10 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    1D-16 (ALTB) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the 1A, 1D and 1F Junction block connectors.

  4. Measure the voltage according to the value(s) in the table below.

    Standard voltage:

    Tester Connection
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    D8-20 (GCTY) - Body ground
    P - Body ground
    Glass hatch courtesy switch input
    Glass hatch is open
    Below 1 V
    Glass hatch is closed
    11 to 14 V
    D10-8 (GHSW) - Body ground
    O - Body ground
    Glass hatch open signal input
    Glass hatch is open
    Below 1 V
    Glass hatch is closed
    11 to 14 V
    D7-26 (GRY2) - Body ground
    Y - Body ground
    NO.1 glass hatch relay signal
    Power switch: on (IG)
    Glass hatch open switch: on
    Below 1 V
    Power switch: on (IG)
    Glass hatch open switch: off
    11 to 14 V
    D7-15 (GRY1) - Body ground
    V - Body ground
    NO.2 glass hatch relay signal
    Power switch: on (IG)
    Glass hatch open switch: on
    Below 1 V
    Power switch: on (IG)
    Glass hatch open switch: off
    11 to 14 V

    If the result is not as specified, the main body ECU (instrument panel junction block) may have a malfunction..