Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (w/ Navigation System)

REAR VIEW MONITOR SYSTEM (w/ Navigation System) > TERMINALS OF ECU

for Preparation Click here



TELEVISION CAMERA ASSEMBLY


  1. Disconnect the S1 camera connector.


    E150739E02

  2. Measure the voltage of each terminal of the wire harness side connector.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S1-3 (CGND) - Body ground
    W - Body ground
    Ground
    Always
    Below 1 V
    S1-4 (CB+) - S1-3 (CGND)
    B - W
    Power source
    power switch on (IG), shift lever R position
    5.5 to 7 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the S1 camera connector.

  4. Measure the voltage and frequency of each terminal of the connector.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S1-1 (CV-) - S1-2 (CV+)
    BR - R
    Display signal
    power switch on (IG), shift lever R position
    See waveform 1
    If the result is not as specified, the camera may have a malfunction.



  5. E119731E01
  6. Reference:
    Oscilloscope waveform

    1. Waveform 1
      Item
      Content
      Measure terminal
      S1-1 (CV-) - S1-2 (CV+)
      Measure set
      0.2 V/DIV., 0.2 μS/DIV.
      Condition
      Power switch: on (IG), Shift lever: R position


NAVIGATION RECEIVER ASSEMBLY (Click here)