Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


DESCRIPTION

This circuit sends a signal to the stereo component amplifier to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier is functioning, no sound, or only an extremely faint sound, can be heard.

WIRING DIAGRAM


E153585E01


INSPECTION PROCEDURE

1.INSPECT STEREO COMPONENT AMPLIFIER


    E151934E03
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    N14-1 (MUTE) - Body ground
    Turn power switch on (ACC), Audio system is playing → Changing
    Above 3.5 V → Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER)


    I101978E32
  1. Disconnect the radio receiver connector and the stereo component amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E2-7 (MUTE) - N14-1 (MUTE)
    Always
    Below 1 Ω
    E2-7 (MUTE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT STEREO COMPONENT AMPLIFIER (OUTPUT SIGNAL)


    E151935E05
  1. Reconnect the stereo component amplifier connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E2-7 (MUTE) - Body ground
    Turn ignition switch on (ACC), Audio system is playing.
    Above 3.5 V



NG
REPLACE STEREO COMPONENT AMPLIFIER
OK

REPLACE RADIO RECEIVER