SFI SYSTEM > INSPECTION MODE PROCEDURE |
| ACTIVATING INSPECTION MODE |
Perform the following steps (1) through (4) in 60 seconds.
Turn the power switch on (IG).
Fully depress the accelerator pedal twice with the transmission in the P position.
Fully depress the accelerator pedal twice with the transmission in the N position.
Fully depress the accelerator pedal twice with the transmission in the P position.
Check that "FWD MAINTENANCE MODE" is displayed on the multi-information display and the master warning light is illuminated in the combination meter.
Turn the power switch on (READY).