Home › SUSPENSION & AXLE › AXLE › AXLE SYSTEM

AXLE SYSTEM > TERMINALS OF ECU

for Preparation Click here



SKID CONTROL ECU

C138589E04

HINT:
Inspect the ECU from the wire harness side while the connector is connected.


Terminal No.
(Symbols)
Wiring Color
Terminal Description
Condition
Specified Condition
A46-1 (GND1) - Body ground
W-B - Body ground
Skid control ECU ground 1
Always
Below 1 Ω
A46-22 (FR+) - Body ground
W - Body ground
Front sensor (+) RH input
Power switch off
Below 1 Ω
A46-32 (FR-) - Body ground
O - Body ground
Front sensor (-) RH input
Vehicle speed input
Pulse generation
(see waveform 1)
A44-1 (GND3) - Body ground
BR - Body ground
Skid control ECU ground 3
Always
Below 1 Ω
A44-2 (GND2) - Body ground
W-B - Body ground
Skid control ECU ground 2
Always
Below 1 Ω
A44-7 (IG1) - Body ground
Y - Body ground
IG1 power
Power switch on (IG)
11 to 14 V
A44-10 (RSS) - Body ground
V - Body ground
Speed sensor shield ground
Power switch off
Below 1 Ω
A44-18 (CANL) - Body ground
W - Body ground
CAN communication
(Send and receive-)
Check DTC using the Techstream
CAN communication's
DTC is not output
A44-19 (CANH) - Body ground
B - Body ground
CAN communication
(Send and receive+)
Check DTC using the Techstream
CAN communication's
DTC is not output
A44-27 (RL+) - Body ground
R - Body ground
Rear sensor (+) LH input
Power switch off
Below 1 Ω
A44-35 (RL-) - Body ground
G - Body ground
Rear sensor (-) LH input
Vehicle speed input
Pulse generation
(see waveform 1)
A47-1 (GND5) - Body ground
W-B - Body ground
Skid control ECU ground 5
Always
Below 1 Ω
A47-2 (GND4) - Body ground
W-B - Body ground
Skid control ECU ground 4
Always
Below 1 Ω
A47-23 (RR-) - Body ground
R - Body ground
Rear sensor (-) RH input
Power switch off
Below 1 Ω
A47-31 (RR+) - Body ground
G - Body ground
Rear sensor (+) RH input
Vehicle speed input
Pulse generation
(see waveform 1)
A45-4 (GND6) - Body ground
W-B - Body ground
Skid control ECU ground 6
Always
Below 1 Ω
A45-5 (IG2) - Body ground
W - Body ground
IG2 power
Power switch on (IG)
11 to 14 V
A45-13 (FSS) - Body ground
V - Body ground
Speed sensor shield ground
Power switch off
Below 1 Ω
A45-22 (FL+) - Body ground
G - Body ground
Front sensor (+) LH input
Power switch off
Below 1 Ω
A45-28 (FL-) - Body ground
R - Body ground
Front sensor (-) LH input
Vehicle speed input
Pulse generation
(see waveform 1)


    C156524E01
  1. Waveform 1 (Reference):
    Item
    Contents
    Tool setting
    1 V/DIV. 2 ms/DIV.
    Vehicle condition
    Driving at approximately 18 mph (30 km/h)

    HINT:
    As the vehicle speed (tire rotating speed) becomes faster, the cycle becomes shorter and the output voltage larger.