Home › SUSPENSION & AXLE › AXLE › AXLE SYSTEM

AXLE SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the Techstream to the vehicle and reading various data output from the vehicle's skid control ECU.
The skid control ECU records DTCs when the computer detects a malfunction in the computer itself or in its circuits.
To check the DTCs, connect the Techstream to the DLC3 on the vehicle. The Techstream enables you to erase the DTCs, activate the various actuators, and check the Freeze Frame Data and Data List.
  1. Check the battery voltage.

    Standard voltage:
    11 to 14 V

    If the voltage is below 11 V, recharge the battery before proceeding to the next step.

  2. Check the DLC3 (Click here).


DIAGNOSIS
  1. Connect the Techstream to the DLC3, turn the power switch on (IG), and attempt to use the tester. If the display indicates that a communication error has occurred, there is a problem with either the vehicle or the Techstream.

    1. If communication is normal when the Techstream is connected to another vehicle, inspect the DLC3 of the original vehicle.
    2. If communication is still not possible when the Techstream is connected to another vehicle, the problem may be in the Techstream itself. Consult the Service Department listed in the Techstream's instruction manual.



  2. C175031E01
  3. Diagnosis system

    1. If the HV control ECU detects that its function to communicate with the skid control ECU fails, or a function that is related to MGR fails, the ECU performs a diagnosis and memorizes the failed sections. Furthermore, the HV control ECU transmits the master caution indicator light (AWD warning illumination) request signal to the combination meter assembly (meter CPU). Then, the combination meter assembly (meter CPU) displays the AWD warning on the multi-information display in the clock assembly to inform the driver. Furthermore, the master caution indicator light illuminates and the buzzer sounds simultaneously.
    2. If the skid control ECU detects a failure in the vehicle stability control system, the ECU performs a diagnosis and memorizes the failed sections. Furthermore, the skid control ECU transmits the master caution indicator light (AWD warning illumination) request signal to the HV control ECU. The HV control ECU transmits this signal to the combination meter assembly (meter CPU). Then, the combination meter assembly (meter CPU) displays the AWD warning on the multi-information display in the clock assembly to inform the driver. Furthermore, the master caution indicator light illuminates and the buzzer sounds simultaneously.