Home › BODY › MIRROR › OUTER MIRROR SWITCH

OUTER MIRROR SWITCH > INSPECTION

for Preparation Click here



1. INSPECT OUTER MIRROR SWITCH ASSEMBLY


B176187E01
  1. The L position of the left/right adjustment switch: Measure the resistance according to the value(s) in the table below.

    Standard resistance (for left side):
    Tester Connection
    Switch Condition
    Specified Condition
    4 (MLV) - 8 (B)
    6 (M+) - 7 (E)
    UP
    Below 1 Ω
    OFF
    10 kΩ or higher
    4 (MLV) - 7 (E)
    6 (M+) - 8 (B)
    DOWN
    Below 1 Ω
    OFF
    10 kΩ or higher
    5 (MLH) - 8 (B)
    6 (M+) - 7 (E)
    LEFT
    Below 1 Ω
    OFF
    10 kΩ or higher
    5 (MLH) - 7 (E)
    6 (M+) - 8 (B)
    RIGHT
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.

  1. The R position of the left/right adjustment switch: Measure the resistance according to the value(s) in the table below.

    Standard resistance (for right side):
    Tester Connection
    Switch Condition
    Specified Condition
    3 (MRV) - 8 (B)
    6 (M+) - 7 (E)
    UP
    Below 1 Ω
    OFF
    10 kΩ or higher
    3 (MRV) - 7 (E)
    6 (M+) - 8 (B)
    DOWN
    Below 1 Ω
    OFF
    10 kΩ or higher
    2 (MRH) - 8 (B)
    6 (M+) - 7 (E)
    LEFT
    Below 1 Ω
    OFF
    10 kΩ or higher
    2 (MRH) - 7 (E)
    6 (M+) - 8 (B)
    RIGHT
    Below 1 Ω
    OFF
    10 kΩ or higher

    If the result is not as specified, replace the switch assembly.