Home › HYBRID SYSTEM ยท P310 › HYBRID TRANSMISSION / TRANSAXLE › OIL PUMP ASSEMBLY

OIL PUMP ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE COOL AIR INTAKE DUCT SEAL
  1. Remove the 11 clips and cool air intake duct seal.



2. REMOVE RADIATOR GRILLE


    B181108E01
  1. Put protective tape around the radiator grille.



    B181109
  1. Remove the 2 bolts and 4 clips.



    B181110
  1. Disengage the 6 claws and 4 guides, and remove the radiator grille.



3. REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)


    B172760E01
  1. Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172761E01
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172763
  1. Remove the 7 screws and clip.



    B172764
  1. Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Remove the front bumper assembly.



4. REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)


    B172760E01
  1. Put protective tape around the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172761E01
  1. Remove the screw.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    HINT:
    Use the same procedure for the RH side and LH side.



    B172763
  1. Remove the 7 screws and clip.



    B172764
  1. Disengage the 4 claws and disconnect the front bumper assembly.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. Disconnect each fog light connector, and then remove the front bumper assembly.



5. DRAIN HYBRID TRANSAXLE FLUID


    C173143E01
  1. Using a socket hexagon wrench 10 mm, remove the filler plug and gasket.

  1. Using a socket hexagon wrench 10 mm, remove the drain plug and gasket.

  1. Using a socket hexagon wrench 10 mm, install the drain plug, and a new gasket.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }



6. REMOVE OIL WITH MOTOR PUMP ASSEMBLY


    C172343
  1. Disconnect the oil pump connector.

  1. Disconnect the 2 oil cooler hoses.

  1. Remove the 2 nuts and oil with motor pump assembly.