Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    58-40    GPS Antenna Error

DTC    58-41    GPS Antenna Power Source Error

DTC    80-40    GPS Antenna Error

DTC    80-41    GPS Antenna Power Source Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
58-40
GPS antenna error
  1. Wire harness
  2. GPS antenna
  3. Navigation receiver assembly
58-41
Error of the power source to the GPS antenna
80-40
GPS antenna error
80-41
Error of the power source to the GPS antenna

INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.CHECK HARNESS AND CONNECTOR (GPS ANTENNA - NAVIGATION RECEIVER ASSEMBLY)
  1. Check that the GPS antenna cord is securely connected to the navigation receiver assembly connector.

    OK:
    The cord is securely connected.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE GPS ANTENNA
  1. Replace the GPS antenna with a normal one and check if the same problem occurs again (Click here).

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same trouble occurs again.

      OK:
      The same problem does not occur.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

END