Home › BODY ELECTRICAL › METER › STEERING PAD SWITCH

STEERING PAD SWITCH > INSPECTION

for Preparation Click here



1. INSPECT STEERING PAD SWITCH


  1. Measure the resistance according to the value(s) in the table below.


    E146927E03


    Standard resistance:

    Tester Connection
    Condition
    Specified Condition
    z2-7 (+DP) - z2-2 (EAC) (*1)
    DISP switch is not pushed in
    10 kΩ or higher
    z2-7 (+DP) - z2-2 (EAC) (*1)
    DISP switch is pushed in
    Below 1 Ω
    z2-7 (+DP) - z2-8 (EAU) (*2)
    DISP switch is not pushed in
    10 kΩ or higher
    z2-7 (+DP) - z2-8 (EAU) (*2)
    DISP switch is pushed in
    Below 1 Ω

    *1: w/ Steering A/C Switch
    *2: w/o Steering A/C Switch

    HINT:
    If the value is not as specified, replace the steering pad switch (Click here).